Snapper Clean Sweep Twin Catcher Manual de usuario

ATTACHMENTOPERATOR’SMANUALClean Sweep Twin CatcherMfg. No. Description1695171 Clean Sweep Twin Catcher1733743Rev. 03Rev. Date 12/2006TP 100-4406-03-AT

8Bag and Chute InstallationCEDABFigure 10. Install Lower Discharge Chute A. Lower ChuteB. Knob, 5/16-18C. Front Carriage Bolt, 5/16-18 x 3/4D. Wing N

Tube Installation9CABCDABEDFigure 11. Install Upper Tube to CoverA. Upper TubeB. CoverC. Ridge, Upper TubeD. Ridge CutoutFigure 12. Install Middle T

Normal Removal &Installation10Normal Removal & InstallationCollector InstallationNote: See previous pages for more detailed installationand op

Normal Removal11A. Hitch Support Assembly G. Middle & Upper TubeB. Cover H. Lower ChuteC. Pin I. PinD. Hair Pins J. Strap MiddleE. Bag K. RidgeF.

Simplicity Mfg. Inc. - Snapper Products535 Macon Street McDonough, GA 30253 www.Snapper.comBriggs & Stratton Yard Power Products Group Copyright ©

1Safety Rules & InformationGeneral Warnings...2Safety Decals ...

2Safety Rules& InformationRead these safety rules and follow them closely. Failure to obey these rules could result in loss of control ofunit, sev

Before OperationClear the lawn of all sticks, stones, wire and other debriswhich may be caught or thrown by the mower blades.Check grass condition. If

InitialInstallation4Before beginning any service work turn off thePTO, set the parking brake, turn off the ignition,and disconnect the spark plug wire

5Pin InstallationComponent InstallationPIN INSTALLATION ON LOWER CHUTE 1. Insert the head of pin (C, Figure 4) through front holeof lower chute (A).

6Component InstallationFigure 8. Install Upright SupportA. HitchB. Upright SupportC. Capscrews, 3/8-16 x 1D. Locknuts, 3/8-16AINSTALL UPRIGHT SUPPORT

Cover Installation7Figure 10. Install Cover AssemblyA. Bag Support BracketB. Cover AssemblyC. Cover Hinge PinsD. Hair PinsE. Hinge PivotsDINSTALL COV