Snapper ELBX10152BV Manual de usuario

AASSSSEEMMBBLLYY IINNSSTTRRUUCCTTIIOONNSSOOPPEERRAATTOORR’’SS MMAANNUUAALLPPAARRTTSS LLIISSTTEuropean Extreme SeriesWalk-BehindLeaf Blower Series 2

105 maintenance (cont.)TROUBLESHOOTING:• UNIT WILL NOT START:• Check fuel and oil levels. • Check to make sure choke is set when engine is cold, off

11• THROTTLE CABLE ADJUSTMENT: Correct cableadjustment allows for full range of movement of throttlebody on engine in conjunction with throttle contro

126 illustrated parts list

136 illustrated parts list (cont.)Item Part No. Qty Description1 7043267 1 WELDMENT, Housing- Extreme Blower, LBX10152BV2 75892 1 DECAL - Danger-Flyin

146 illustrated parts list (cont.)Item Part No. Qty Description43 90391 4 WASHER, 5/16" Internal Tooth Lock44 3071800 1 THROTTLE CONTROL, Briggs4

157 decal identification75893 - EAR/EYE/BREATHING PROTECTIONREQUIRED - LOCATED ON SIDE OF BLOWERHOUSING75892 - DANGER-FLYING MATERIAL -LOCATED ON SIDE

167 decal identification (cont.)73462 - WARNING COMBO - LOCATEDON TOP OF BLOWER HOUSINGEUROPEAN PERFORMANCE:Maximum level of vibration measuredat the

17notes

18notes

19notes

21 preliminariesCongratulations!You have just purchased one of the finest pieces of outdoor power equipment on the market today. If properly cared fo

20AASSSSEEMMBBLLYY IINNSSTTRRUUCCTTIIOONNSSOOPPEERRAATTOORR’’SS MMAANNUUAALLPPAARRTTSS LLIISSTTEuropean Extreme SeriesWalk-BehindLeaf Blower Series

TRAINING• Read, understand, and follow all instructions in the manu-al and on the unit before starting. If the operator(s) ormechanic(s) can not read

CHILDRENTragic accidents can occur if the operator is not alert to thepresence of children. Children are often attracted to the unitand its activity.

53 unit assemblyNote: Please refer to Parts List for correct part identification and placement.FRONT WHEEL ASSEMBLY• Place Mounting Bracket against lo

64 unit operationSTARTING THE ENGINEIMPORTANT NOTE: The procedures outlined within this section are general guidelines, and are in no way meant to rep

74 unit operation (cont.)TO SHUT ENGINE DOWN:• Move engine speed control to slow “Turtle” position.• Allow engine to idle for 2-3 minutes before shutt

84 unit operation (cont.)GENERAL RULES TO OBSERVE BEFORE AND DURING OPERATION:• Inspect your unit before each and every use. Check for worn, bent or

95 maintenanceGENERAL:• Follow implicitly the engine manufacturer’s recommendations for maintenance.• Always keep your machine clean – especially the